- 260 Lumens Max White Light Output
- Red and White Light Sources
- Ultra Compact
- USB Type-C Charging port
- All Metal Keychain Light
- Outputs (Runtimes)
- High – 260 Lumens (45 Minutes)
- Med – 80 Lumens (1hr 15Min)
- Low – 30 Lumens (3hr)
- Eco – 5 Lumens(18hr)
- Red – 4 Lumens (5hr 30 min)
- 1 meter impact resistance
- IP66 Water Resistance Rating
- Single switch operation
- Recessed Switch to avoid accidental activation
- Lockout Function
- Aluminum A6061-T6 Body
Press and hold the switch for 0.5 seconds to turn on/off the light.
Press and hold the switch for 1.2 seconds to turn on the red light.
Output Selection for Keychain Flashlight
White light: single click the switch to cycle through Eco→Low→Med→High.
Red light: single click the switch to cycle through Red→Red Flash.
Lock: with the light switched off, double click the switch to lock the light, the light will blink twice on Low to indicate locked status.
Unlock: with the light locked, double click the switch, the light will be unlocked and activated on Low.
In locked status, clicking or pressing the switch will activate 2 one-second blinks on Low to indicate locked status.
Charging Your Keychain Flashlight
First switch off the light and plug the USB A socket of the charging cable into an electrical outlet, then connect the USB Type-C socket of the charging cable to the light.
The indicator will display red while charging, and will turn to green when fully charged.
Once charging is completed, be sure to close the anti-dust cover.
The normal charging time is approximately 1 hour and 20 minutes from depletion to full charging.
Recharge a stored light every four months to maintain optimum performance of the battery.
Battery Level Indication
With the light switched off, single click the switch to check the battery status. The battery level indicator will display the battery status for 3 seconds.
Green constant on: saturated (100% – 70%)
Green flashes: sufficient (70% – 40%)
Red constant on: poor (40% – 10%)
Red flashes (2Hz): critical (10% – 1%)
Note: The battery status will be displayed each time the light is switched on.
The light will accumulate a lot of heat when used on High output level for extended periods. To reduce the temperature, the light will automatically step down a few lumens. High output level can be reselected if needed.
When the voltage level drops below the preset level, the flashlight is programmed to downshift to a lower brightness level until Eco output is reached. When this happens on Eco output mode, the battery level indicator blinks red to remind you to recharge the battery. To ensure normal use, the flashlight will not turn off automatically and will work till the battery is depleted.
- Fenix E03R Flashlight
- Key chain ring
- User Manual
- Warranty Card